Promax TVHUNTER, User Manual

Page: 46 / 90

USER’S MANUAL. TVHUNTER .
Page 10 10/2010
3.3 Main Screen Description.
The top line of this screen is the same one for all functions of the equipment. Next
it will be explained the icons and messages that can appear depending on the situation.
At the top left corner it is shown the active function. There are three different
states or functions: 1) DETECT , 2) IDENTIFY and 3) ADJUST .
Figure 4.- Main Screen (on Detect Screen).
When using the TVHUNTER , it may appear on the display some messages and
icons, depending on the status or event is taking place. These messages and icons are
detailed below:
Message Description
"LOW BATTERY" Low power level battery. Plug it to the charger.
"VERY LOW BATTERY" The equipment will be switched off immediately.
"SUPPLY SHORT CIRCUIT" The external supply can be shortcut.
"SUPPLY OVER CURRENT" The external supply has a high current consumption.
"MANUAL POWER OFF" The instrument has to be switched off by hand.
"AUTO POWER OFF" The instrument will switch off after five minutes of inactivity.
"SERVICE MODE" Normal operation mode.
"BATTERY MODE" When the battery is being charged.
"UPDATE MODE" When the instrument is being updated.
“NETWORK NOT FOUND” The instrument cannot find a TV network.
“SERVICES NOT FOUND” The instrument cannot detect the services of a network.
"SIGNAL NOT DETECTED" When no signal is detected.
"FULL BATTERY" Battery fully charged.
"MPEG-2 NOT DETECTED" It is not detecting the Transport Stream MPEG-2 signal.
"LOADING NETWORK" After finding a signal, needs a time to load the network.
"LOADING SERVICES" After finding a network, needs a time to load services.
"HIGH TEMPERATURE"
The running temperature is too high. The instrument must
be switched off for a while. If the problem persists, contact
with the technical support.