25
Chapter 6
OPERATING INSTRUCTIONS
Programming the Appliance
1. Unlock and open the door.
2. Turn on the power by pressing
:
on the control panel.
3. Set the Clock.
• Turn the dial to
Set Clock. The day-of-the-week icon will blink.
• Adjust the day forward or backward using
E
or
F
on the right side of the control panel.
• Press the
Set button on the lower left corner of the LCD display. The time will blink.
• Adjust the time forward or backward using
E
or
F
on the right side of the control panel. AM or PM
is indicated on the lower right side of the time digits.
4. 24/7 Mode.
• If you want AQ550 to run continuously — 7 days a week, 24 hours a day — turn the dial to
Run 24/7. If
not, skip to Step 5.
• You can adjust the fragrance intensity level (1 to 50) using the
E
or
F
buttons. Refer to Selecting
Scent Intensity for the intensity level to set.
5. Set Multi-Program Timer.
• Turn the dial to
Set Program. The Program icon comes on.
• The day-of-week icons will all blink, indicating you are selecting all days with the same program. If
you want to program a specific day, use the
E
or
F
buttons to select the day. You can set maximum
of 3 on/off programs same for every day or individually for each day. After selecting the day, press
the
Set button to advance.
• Now the “1” icon is turned on to indicate you are setting program 1. The Rate digits blink to prompt
you to set the rate. You may set to any value between 1 and 50, or set to 0 to disable the program.
Press the
Set button to advance.
• If you set the rate to 0, then the current and subsequent programs are all disabled. For example, if
the rate for program 2 is 0, then program 2 and 3 are disabled.
• If you set a non-zero rate, then the rate digit changes to “S” to indicate start time. The hour digit
should blink to prompt you to set the start hour. Use the
E
or
F
buttons to set the hour. Then press
the
Set button to advance and set the minute. Press the Set button to advance.
• The rate digit now changes to “E” to indicate you are setting the end time. Use the +/- buttons to set
the end time. Press the Set button to advance to the next program.
• Program icon 2 should now turn on. Use the
E
or
F
and
Set buttons to set the start and end times
for program 2 and then for program 3. Note that if you need only 1 or 2 programs for the day, you
simply disable the subsequent programs by setting their rates to 0.
• After setting the programs, turn the dial to
Run Program.
6
