5.
Make the Electric Connections
WARNING
: To avoid possible electrical
shock, be sure electricity is turned off at the
main fuse box before wiring.
NOTE:
This remote control unit is equipped
with 16 code combinations to prevent
possible interference from or to other remote
units. The frequency switches on your
receiver and transmitter have been preset at
the factory. Please recheck to make sure the
switches on the transmitter and the receiver
are set to the same position, any combination
of settings will operate the fan as long as the
transmitter and receiver are set to the same
position.(Figure 8)
Step 1.
(Figure 9)
Insert the receiver into the
mounting bracket with the flat side of the
receiver facing the ceiling.
Step 2.
(Fig. 10)
Motor to Receiver Electrical
Connections: Connect the Black wire from
the fan to Black wire marked "TO MOTOR
L". Connect the White wire from the fan
to the White wire marked "TO MOTOR N"
from the receiver. Connect the Blue wire
from the fan to the Blue wire marked "For
Light" from the receiver. Secure wire
connections with the plastic wire nuts
provided.
Step 3.
(Figure 10) Receiver to House Supply
Wires Electrical Connections: Connect the
black (hot) wire from the ceiling to the black
wire marked "AC in L" from the receiver.
Connect the white(neutral) wire from the
ceiling to the white wire marked "AC in N"
f r o m t h e R e c e i v e r. S e c u r e t h e w i r e
connections with the plastic wire nuts
provided.
Step 4.
(Figure 10) If your outlet box has a
ground wire (green or bare copper) connect it
to the fan ground wires; otherwise connect
the hanging bracket ground wire to the
mounting bracket. Secure the wire connection
with a plastic nut provided. After connecting
the wires spread them apart so that the green
and white wires are on one side of the outlet
box and black and blue wires are on he other
side. Carefully tuck the wire connections up
into the outlet box.
Note:
Fan must be installed at a maximum
distance of 20 feet from the transmitting unit
for proper signal transmission between the
transmitting unit and the fan's receiving unit.
Figure 9
Receiver
Hanger
bracket
Figure 8
Code switch
ON