5
4
5. Insert the Seat Post (10) into the Frame (1). Press
the Frame Bushing (40) into the Frame. Align one of
the holes in the Seat Post with the hole in the
Frame. Insert the Seat Pin (35) through the Frame
and the Seat Post to select the desired seat height.
Make sure to insert the Seat Pin through one of
the holes in the Seat Post; do not insert the Seat
Pin under the Seat Post.
Next, attach the Seat (11) to the Seat Post (10) with
one M8 x 50mm Carriage Bolt (36) and one M8
Nylon Locknut (39).
Batteries
7
37
7
8
36
39
11
1
10
35
40
Console
Wire
Console
Plate
21
20
6
6. Identify the Left Pedal (21). (The Left Pedal is
marked with an “L.”) Using an adjustable wrench,
tighten the Left Pedal counterclockwise into the left
arm of the Crank (20).
Tighten the Right Pedal (not shown) clockwise into
the Right arm on the Crank.
7. Make sure that all parts are properly tightened before you use the exercise cycle. Note: There may be
some hardware left over after assembly is completed.
4. The Console (7) requires two "AA" batteries (not
included). Alkaline batteries are recommended.
Refer to the inset drawing. Press two batteries into
the battery compartment on the back of the console.
Make sure that the negative ends of the batteries
(marked “–”) are touching the springs in the bat-
tery compartment.
Connect the console wire to the Extension Wire
(37).
Attach the Console (7) to the console plate with four
Console Screws (8).
5
