ProFlow PF-BTA, Technical Manual

Page: 11 / 32

ELECTRONIC CONTROL PANEL
Page 11
PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS

Before entering the programming mode, make sure that
the appliance is in the service mode.

In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1.
Press the scroll button and hold it for 2 sec until the
display shows:

Press the up or down button to set the
language.
2.
Press the scroll button again; the display will show:

Press the up or down button to set the time of
day.
3. Press the scroll button again; the display will show:
 Press the up or down button to set the unit of
measure for water hardness. Make sure it is identical
to the unit of measure of the water hardness test kit
or water analysis report that is used to determine the
hardness of the incoming untreated water!
4.
Press the scroll button again; the display will show:

Press the up or down button to set the hardness
of the incoming untreated water.
5. Press the scroll button again; the display will show:

Press the up or down button to enable the
buzzer by setting the sound level, or disable the buzzer
(OFF).
6. Press the scroll button again; the display will show:

Press the up or down button to save the settings
into the NOVRAM® and exit the programming mode.
PROGRAMMING INSTRUCTIONS -
CONFIGURATION PARAMETERS

Before entering the programming mode, make sure that
the appliance is in the service mode.

All configuration parameters on this appliance have
been pre-programmed in the factory, to offer optimal
performance in a wide range of applications and situations.
Nevertheless it may be necessary or desirable to change any
of these parameters, to further optimize the appliances
performance or to adapt it to the specific requirements of
the installation.

In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1.
Press the scroll button and hold it for 6 sec until the
display shows:
2.
Within 10 sec, press the up button; the display will
show:

Press the up or down button to set the units of
measure (Metric or US).
3. Press the scroll button again; the display will show:

Press the up or down button to activate the
maintenance reminder function by setting the
maintenance interval, or deactivate the maintenance
reminder function.
4.
Press the scroll button again; the display will show:

Press the up or down button to set the
exchange capacity per litre of filter media.
5.
Press the scroll button again; the display will show:

Press the up or down button to set the age
correction factor (%/year) to compensate for capacity
loss of the filter media due to aging.
System Check
ExCap:3.8°f M3/L
Age corr.: 2.0%
Units:Metric
MaintInt: 24mths
Language:English
Set time: 8:01
Set hardn: XX °f
HardUnit: °f
Exit
Buzzer: 2