15
ProSear
Installation Instructions
Service & Wiring Diagram
The
ProSear
Indoor Infrared Grill was designed with a removable control panel that houses all the electronics & gas compo-
nents. See Figure K, page 13. This exclusive feature allows for the easy repair or replacement of all electrical and gas compo-
nents of your grill.
Removing the Control Panel:
First, unplug the electric cord to the grill, shut off the gas and disconnect the gas line from the
grill. Remove the valve knob & Stainless Steel trim and remove the grill from cabinetry. See page 7. Next, remove the 4 x 7/16
nuts that hold the control panel to the body of the grill. See page 13. Disconnect the electrode wire (
Fig. Q)
from the electrode.
Replacing the Control Panel:
After the module has been repaired or replaced, reinstall the control panel onto the grill body by
reversing the above procedure. Reinstall the grill into the cabinetry by following the directions on page 7. The unit and all its gas
connections should then be checked for leaks. See page 6
Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper operation after servicing.
Wiring Diagram
Wiring Diagram
Electrode Wire
Fig. Q
