» INSTALLATION INSTRUCTIONS
/ OCTO / OCTO + / HEXA
10
proswell.fr
To hold the track in position, drive in a screw 2 cm from
each end. Next finish attaching the track by driving in
screws at 20 cm intervals. Use Ø4 x 35 screws (bag D).
FITTING THE UNDERLAY:
Important !
The ground underneath the underlay should be absolutely flat and free of any bumps or rough areas.
Because of the pressure exerted by the water, even the smallest bump will be visible underneath the liner. After clearing
the ground, spread a layer of sand mixed with cement (1 part cement to 7 parts sand) over the floor of the pool and
compact it. This layer should be no more than 1 cm deep. (The sand and cement are not supplied). Unfold the underlay
in the pool taking care to line it up correctly with the corners. Smooth out any wrinkles. The underlay will be slightly
smaller than the pool structure.
18
19
17
Each side of the pool is fitted with one track 1.18 m long and another track trimmed to fit, see the table below.
Trim 8 tracks according to the table below. Before making the cuts, check that the total length of the track is equal to the
length of the wall less 10 cm. Use a mitre box to ensure that the cuts are clean and straight. Deburr the cuts using the
fine grain file.
Pool model
Short side
Hexa 410
1.18+0.61
Octo 360
1.14
Octo 414
1.18+0.26
Octo 505
1.18+0.61
>>
FITTING THE FELT UNDERLAY