proswell.fr
»
INSTALLATION INSTRUCTIONS
/ OCTO / OCTO + / HEXA
7
>>
ASSEMBLY OF THE OCTO & HEXA POOL STRUCTURE
Fit the 4 half slats (type A - smooth side facing down) together with 4 male/ female slats (type B), grooves facing down,
double tongues facing up (see the detail below).
- Before you begin, familiarise yourself with the
nomenclature enclosed in the “Waterproofing” kit and the
exploded view (at the end of this notice) that corresponds
to your pool.
- Determine the final orientation of your pool, by preference,
the skimmers should be oriented so that they are facing
into the prevailing winds. Skimmers must be mounted on a
side that starts with a type A slat.
- While assembling the walls, make sure that each slat is fully
engaged before starting on the next.
- You may need to use a hammer and a clamp to remedy any
slight warping of the slats. Do not strike the wood directly,
use the protective brace (provided).
- During assembly, check regularly that the walls are level
and the 4 diagonals are equal in length.
- To avoid the risk of injury or damage to the liner, take care
to eliminate any splinters during and after assembly.
- If you intend to fit your pool with a counter swim treadmill,
you will need to incorporate the 2 slats specially prepared
to mount this option.
At this point, fit the skimmer or autonomous filtration unit
into the bottom skimmer slat (type D) .
Fit the two slats at aither side of the filtration unit or fit
the op skimmer slat (type E) over the bottom skimmer slat
(type D), and continue around the pool with 3 type F slats
and 4 type G half-slats as illustrated.
4
5
6
3
Fit together the remaining slats (type B) taking care to
position the slat that will hold the return fitting (type C)
and the machined slat (type D) correctly. The slat that
will hold the return fitting should be positioned over 4
(type B) slats + 1 type A slat in the case of a skimmer
and an autonomous filtration unit. The return fitting slat
should be located just under the machined (type D) slat
which should be in the last row of slats at this point in the
assembly.
Ø 505 300 cm
Ø 414 250 cm
Model
D1
OCTO 414 379 cm
OCTO 505 470 cm
B
F
A
SEMI-FEMALE
PROFILE
MALE/ FEMALE
PROFILE
FEMALE
PROFILE
MALE
PROFILE
G
The wooden brackets will support the coping that will
be mounted after the pool is filled. Pre-drill the wall from
inside the pool then attach each wooden bracket (type L)
using 2 screws (5x100mm sachet J) taking care to position
them flush with the top of the structure. Remove any
splinters that may have been raised during this process.
7
Ø
5 x 80mm
