proswell.fr
»
INSTALLATION INSTRUCTIONS
/ OCTO / OCTO + / HEXA
9
IMPORTANT !
Check that the structure is correctly assembled
before mounting the liner locking track.
To do this:
- use a spirit level to check that the structure is horizontal
around the entire periphery.
- check that the 4
diagonals are equal in length.
Fix any imperfections before continuing.
The liner locking track should be flush with the top of the
wooden structure.
Before mounting the liner locking track, pre-drill using a
Ø 3mm drill bit.
Avoid over tightening, this could cause the screws to
break through the track.
16
There is 1 wooden bracket per side (except the side
holding the skimmer). Position the wooden bracket in the
centre of the slat.
15
14
The wooden brackets will support the coping that will
be mounted after the pool is filled. Pre-drill the wall from
inside the pool then attach each wooden bracket (type L)
using 2 screws (5x100mm sachet J) taking care to position
them flush with the top of the structure. Remove any
splinters that may have been raised during this process.
At this point, fit the skimmer into the bottom skimmer slat
(type D) before fitting the type E slat.
12
13
>>
MOUNTING THE LINER LOCKING TRACK
75 cm
Mount 2 wooden brackets on the wall holding the
skimmer, they should be positioned 75 cm apart and
equidistant from the skimmer axis.
Ø
5 x 80mm
Mount a decorative profile (type H) on the end of each wall
using nails (3.1x75mm) inserted through evenly spaced holes
pre-drilled along the axis of the profile
.