CIRCUIT PROTECTION
All
Wobblelight
®
models are equipped with an externally re-settable circuit breaker located beneath the power switch. The breaker will trip when the total amperage load on
Wobblelight
®
exceeds 12 amps. If the breaker trips, the lamp circuit and the accessory outlet will be immediately de-energized. The following steps should be taken in the event of
a circuit breaker trip:
1. Disconnect
the
Wobblelight
®
with the tripped circuit breaker from the power source and turn the power switch to the “off” position.
2.
Insure that the power source is 120-volt, 60-Hz, 15-amp service.
3.
Determine if the Wobblelight
®
accessory plug was electrically overloaded by checking the number and type of all downstream electrical devices that are plugged into the
accessory outlet.
4.
If it is possible that the labeled amperage rating on the accessory outlet was exceeded, disconnect all electrical devices from the accessory outlet and reset the circuit
breaker by pushing the tab back into the breaker until it clicks into position.
5. Reconnect
the
Wobblelight
®
to the power source and turn the power switch on.
6.
If the Wobblelight
®
does not illuminate, turn the unit off, disconnect from the power source and take out of service (remember to allow up to 10 minutes for a metal halide
lamp to restart from hot condition).
7.
If the Wobblelight
®
illuminates, you can begin to reconnect the electrical devices plugged into the accessory outlet one at a time. Be aware of the total amp load being
placed on the accessory outlet.
8. If the circuit breaker trips again, the accessory outlet is likely being overloaded. Disconnect the
Wobblelight
®
from the power source, t
urn the power switch to
the “off” position and disconnect one or more electrical devices from the accessory outlet.
9. Reset the circuit breaker and repeat steps 5-7.
10.
If the circuit breaker continues to trip and you are certain that the accessory outlet amp rating is not being exceeded (or if nothing is connected to the
accessory plug), disconnect the
Wobblelight
®
and take it out of service.
11. Contact Wobblelight
®
customer service or your local authorized service center for repairs and/or replacement parts.
12. Wobblelight
®
models supplied with Metal Halide lamps are protected with an internal fast-blow glass fuse. If this fuse blows then the Wobblelight
®
transformer, capacitor
and lamp must all be replaced by an authorized electrician.
CAUTION:
The Wobblelight
®
circuit breaker and fuse are important safety features.
x
Do not remove, alter or disable the Wobblelight
®
circuit breaker and fuse.
x
Do not operate Wobblelight
®
without the circuit breaker and fuse in place.
x
Do not use tape or similar means to try holding the breaker in a permanent “reset” position. The breaker will still trip.
x
Any improper use or modification of the circuit breaker or fuse will void the warranty.
QUESTIONS OR PROBLEMS?
Call ProBuilt Professional Lighting Customer Service and Technical Support at 877-707-0800 (Monday-Friday from 8:30 am until 5:00 pm Central
time) or e-mail to
anytime.
Wobblelight
®
LIMITED WARRANTY INFORMATION
Manufacturer’s Limited Warranty
Wobblelight® products manufactured by ProBuilt Professional Lighting LLC are warranted against defects in material and workmanship for a period of one year from date of
purchase. ProBuilt Professional Lighting LLC will repair or replace any defects due to faulty materials or workmanship during the warranty period. Proof of purchase and
compliance with all product use information is required. A restocking fee of 15% will be charged for all non-defective goods. Shipment or delivery of defective products for warranty
repair or replacement is the responsibility of the purchaser.
