x
Although the halogen lamp inner capsule may continue to operate if the outer bulb is broken or damaged, discontinue use immediately and replace with a
new lamp. The inner halogen lamp generates ultraviolet radiation which can cause skin and eye irritation with prolonged exposure.
x
Never expose an operating lamp to moisture such as rain, sleet or snow.
x
Avoid excessive bumping and bouncing during operation since mechanical shock can cause shattering and failure of the halogen lamp.
x
Always operate the halogen lamp with the Wobblelight
®
dome and cap assembly in place prevents personal injury or property damage.
x
Only operate lamp in the upright operating position.
HALOGEN LAMP INSTALLATION
1. Disconnect
Wobblelight
®
from power source and turn off switch.
2. Allow dome and lamp to cool completely.
3. Remove
the
Wobblelight
®
dome / cap assembly by removing the five mounting screws.
4. Screw lamp firmly but not forcibly into socket in order to avoid breakage. Tighten bulb until it is secure in the socket – do not over tighten.
5. Reinstall
the
Wobblelight
®
dome / cap assembly by aligning the five mounting holes with the five mounting nuts (note the dome handle should be aligned
with the power switch).
6. Re-install the five mounting screws – do not over tighten.
SAVE THESE INSTRUCTIONS
Wobblelight
®
General Operating Instructions – All Models
ASSEMBLY
Your Wobblelight
®
carton should include the following parts:
x
Yellow
Wobblelight
®
fixture.
x
Dome / cap assembly.
x
Lamp (metal halide, halogen or fluorescent).
x
Dome screw packet containing five (5) screws (1/4” x 5/8” Phillips button-head sheet metal screw).
If there are any parts missing or damaged, DO NOT contact your Wobblelight
®
retailer. Please contact ProBuilt Professional Lighting
Customer Service toll-free at 877-707-0800 or by e-mail at [email protected]
Instructions for Wobblelight
®
assembly:
1. Remove and verify the contents of your Wobblelight
®
carton.
2. Install the bulb (metal halide, halogen or fluorescent) into the socket by screwing the lamp firmly but not forcibly into socket in order to avoid breakage.
3. For the 120-watt fluorescent bulb only – grasp bulb by the plastic base and not the glass tubes. DO NOT REMOVE SILICONE BUMPERS which are in place to protect the
bulb from breakage.
4. Tighten bulb until it is secure in the socket – do not over tighten.
