Getting Started
1. Power on the transmitter.
2. Connect the battery.
3. Perform a
CONTROL DIRECTION TEST
with the
transmitter.
4. Launch the boat into the water and start sailing.
Install fully charged batteries in your boat and
transmitter.
Make sure the boat is bound to the transmitter
(otherwise, bind the boat to the transmitter
using the included
BINDING
instructions).
Make sure all linkages move freely on the boat.
Adjust the steering rate on your transmitter as
desired.
Find a safe and open area of operation.
Plan a safe rout for the water and wind
conditions.
2
2.4 GHz
BATTERY
POWER
ON
OFF
N
N
R
R
CH2 REV.
CH1 REV.
1
POWER
ON
OFF
5
EN
18 READY-TO-RUN SAILBOAT
Battery Installation
1. Align the polarity (+ and -) of 4 fully charged AA
batteries with the markings in the battery holder
and install the batteries.
2. Install the battery holder in the boat.
3. Before you sail, connect the holder connector to the +
and - BD (bind) port pins on the included receiver.
NOTICE:
Always attach the red (+) wired connector
to the + pin and the black (-) wired connector to the
- pin or damage to the receiver will occur.
4. Apply clear tape to the receiver's antenna so the
end is kept above the boat's waterline for the best
reception of the transmitter signal.
Install the battery holder and the receiver so that no
parts interfere with movement of the servos and
control lines.
5. Install the hatch on the boat.
Tip:
We recommend applying tape (DYNM0102, sold
separately) over the hatch and hull to keep out water.
