4
EN
Westward
™
Display Stand Assembly
1. Apply glue to the tabs (
A
) and insert them into the
slots (
C
) of one end piece of the display stand as
shown.
2. Apply glue to the other ends of the tabs and insert
them into the slots of the other end piece of the
display stand.
3. Ensure the glue is fully dry before putting the boat
on the stand.
Tip:
The front and rear supports fit the curves
of your boat. The lower supports (
B
) can be used
to display the name of the boat, if desired.
Boat Assembly
1. Install the keel posts (
A
) in the bottom of the boat
as shown.
2. Remove the boat hatch on top of the boat and secure
the keel post using the included washer and nut (
B
) as
shown.
Tip:
Some mast lines may be loose from the boat's
eye bolts for shipping purposes. Where a mast line
is loose, put the line loop in the eye bolt. Refer to
Trimming instructions for tightening control lines
on your boat.
Rudder Service
If needed, loosen the setscrew
(
C
) in the rudder steering arm and
remove the arm (
D
) from the rudder
post and the rudder from the boat.
If installing the rudder, tighten the
steering arm's setscrew on the flat
spot on the rudder post. The rudder
arm holes must be on the right side
of the boat. The recommended
factory linkage settings are the
middle hole of the 3 holes in the
rudder arm and the second hole
from the outer most end of the
6-hole servo arm.
B
A
C
A
B
C
D
