When You Are Finished
1. Disconnect the battery.
2. Power off the transmitter.
3. Remove the battery from the boat.
4. Loosen all lines.
Always power off the receiver before powering
off the transmitter to maintain control of the
boat and to retain transmitter binding.
Fully dry the inside and outside of the boat.
Remove the hatch before storing your boat.
Repair any damage or wear to the boat.
Make note of lessons learned from the
trimming of your boat, including water and
wind conditions.
Always store the boat open (without the hatch
sealed) or moisture can cause mold and mildew
to grow in the boat.
NOTICE:
When you are finished boating, never leave
the boat in direct sunlight or in a hot, enclosed area
such as a car. Doing so can damage the boat.
Repair
Repair this model using CA (cyanoacrylate adhesive) glue
or clear tape. Apply a small amount of CA to the end of
the line in order to decrease line and knot fraying. We
do not recommend applying CA to fittings or stays on
the boat, however applying CA to knots will keep them
from loosening. When parts are irrepairable, refer to
replacement and optional parts lists at the back of this
manual.
1
3
POWER
ON
OFF
2
2.4 GHz
BATTERY
POWER
ON
OFF
N
N
R
R
CH2 REV.
CH1 REV.
10
EN
Westward
™
