Westward
limited Warranty
What this Warranty Covers
Horizon Hobby, Inc. (“Horizon”) warrants to the original
purchaser that the product purchased (the "Product") will
be free from defects in materials and workmanship at the
date of purchase.
What is Not Covered
This warranty is not transferable and does not cover
(i) cosmetic damage, (ii) damage due to acts of God,
accident, misuse, abuse, negligence, commercial
use, or due to improper use, installation, operation or
maintenance, (iii) modification of or to any part of the
Product, (iv) attempted service by anyone other than a
Horizon Hobby authorized service center, (v) Product
not purchased from an authorized Horizon dealer, or
(vi) Product not compliant with applicable technical
regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE,
HORIZON MAKES NO OTHER WARRANTY OR
REPRESENTATION, AND HEREBY DISCLAIMS
ANY AND ALL IMPLIED WARRANTIES, INCLUDING,
WITHOUT LIMITATION, THE IMPLIED WARRANTIES
OF NON-INFRINGEMENT, MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE. THE
PURCHASER ACKNOWLEDGES THAT THEY ALONE
HAVE DETERMINED THAT THE PRODUCT WILL
SUITABLY MEET THE REQUIREMENTS OF THE
PURCHASER’S INTENDED USE.
purchaser’s Remedy
Horizon’s sole obligation and purchaser’s sole and
exclusive remedy shall be that Horizon will, at its option,
either (i) service, or (ii) replace, any Product determined
by Horizon to be defective. Horizon reserves the right
to inspect any and all Product(s) involved in a warranty
claim. Service or replacement decisions are at the sole
discretion of Horizon. Proof of purchase is required
for all warranty claims. SERVICE OR REPLACEMENT
AS PROVIDED UNDER THIS WARRANTY IS THE
PURCHASER’S SOLE AND EXCLUSIVE REMEDY.
problem
possible Cause
Solution
Tends to dive in the
water or takes on water
Sails are rigged too high or low
on the mast
Adjust the tightness of the rigging at
the top corner and bottom of each sail
Sails are tied too tight
Loosen lines
The boat hull is not completely closed
Dry out the boat and ensure the hatch is fully
closed on the hull before returning the boat
to the water
Boat will not respond to
throttle but responds to
other controls
Throttle is not at idle and/or throttle trim
is too high
Reset controls with throttle stick and throttle
trim at lowest setting
Throttle servo travel is lower than 100%
Make sure throttle servo travel is 100% or
greater
Throttle channel is reversed
Reverse throttle channel on transmitter
Boat will not Bind
(during binding) to
transmitter
Transmitter is too near boat during
binding process
Move powered transmitter a few feet from
boat, disconnect and reconnect battery to boat
Boat or transmitter is too close to large
metal object
Move boat or transmitter away from large
metal object
Bind plug is not installed correctly in bind
port extension
Install bind plug in bind port and bind boat to
transmitter
Boat battery/Transmitter battery charge
is too low
Replace/recharge batteries
Boat will not link (after
binding) to transmitter
Transmitter is too near boat during
linking process
Move powered transmitter a few feet from
boat, disconnect and reconnect battery to boat
Boat or transmitter is too close to large
metal object
Move boat or transmitter away from large
metal object
Bind plug is left installed in bind port
Rebind transmitter to boat and remove bind
plug before cycling power
Boat battery/Transmitter battery charge
is too low
Replace/recharge batteries
Transmitter may have been bound to
a different model (using different DSM
Protocol)
Bind boat to transmitter
Controls reversed
Transmitter settings are reversed
Perform the Control Direction Test and
adjust controls on transmitter appropriately
8
EN
