Westward
3
EN
18.125”
4.375”
30.5”
22.75”
5.827”
Contents
Specifications
length
18.125 in (460mm)
Beam
4.375 in (111mm)
Mast Height
22.75 in (578mm)
Total Height
30.5 in (775mm)
Keel Depth
5.827 in (148mm)
Transmitter
Spektrum 2.4GHz 2-stick
Transmitter (DX2M)
Receiver
Spektrum
™
MR200
Hull Material
ABS
Sail Material
Rip-stop nylon
Sail Area (Main)
66 in (1676mm)
Sail Area (Jib)
45.75 in (1162mm)
Sail Area (Overall)
111.73 in (2838mm)
Tip:
8 AA batteries (sold separately) are
required to operate the boat and transmitter.
Display Stand Assembly
1. Apply glue to the tabs (
A
) and insert the 4 support
tabs in the slots (
C
) of one end piece of the display
stand as shown.
2. Apply glue to the other ends of the tabs and insert
them into the slots of the other end piece of the
display stand.
3. Ensure the glue is fully dry before putting the boat
on the stand.
Tip:
The front and rear supports fit the curves
of your boat. The lower supports (
B
) can be used
to display the name of the boat, if desired.
Boat Assembly
1. Install the keel posts (
A
) in the bottom of the boat
as shown.
2. Remove the boat hatch on top of the boat and secure
the keel post in the boat using the included washer
and nut (
B
) as shown.
Tip:
Some mast lines may be loose from the boat's
eye bolts for shipping purposes. Where a mast line
is loose, put the line loop in the eye bolt. Refer to
Trimming instructions for tightening control lines
on your boat.
Rudder Service
If needed, loosen the setscrew (
C
) in
the rudder steering arm and remove
the arm (
D
) from the rudder post and
the rudder from the boat. If installing
the rudder, tighten the steering
arm's setscrew on the flat spot
on the rudder post. The rudder arm
holes must be on the right side of
the boat. The recommended factory
linkage settings are the middle hole
of the 3 holes in the rudder arm
and the second hole from the outer
most end of the 6-hole servo arm.
B
A
C
A
B
C
D
