ProBoat Shockwave PRB0600, Owner'S Manual

Page: 4 / 56

Shockwave 26
Charging Warnings
WARNINg:
Failure to exercise caution while
using this product and comply with the following
warnings could result in product malfunction,
electrical issues, excessive heat, FIRE, and
ultimately injury and property damage.
• Read all safety precautions and literature prior to use
of this product.
• Never leave the battery and charger unattended
during use.
• Never allow children under 14 years of age to charge
battery packs.
• Never attempt to charge damaged batteries.
• Never charge a battery if the cable has been pinched
or shorted.
• Never allow the batteries or charger to come into
contact with moisture at any time.
• Never charge batteries in extremely hot or cold places
(recommended between 50–80°F (10–26°C)) or in
direct sunlight.
• Always use only Ni-MH rechargeable batteries. This
charger cannot charge batteries such as “heavy duty",
“alkaline battery” or “mercury battery.”
• Always connect to the charger correctly.
• Always disconnect the battery and charger after
charging and let them cool between charges.
• Always inspect the battery before charging.
• Always terminate all processes and contact Horizon
Hobby if the product malfunctions.
• Always make sure you know the specifications of
the battery to be charged or discharged to ensure
it meets the requirements of this charger.
• Always connect the charge cable to the charger
first, then connect the battery to avoid short circuit
between the charge leads. Reverse the sequence
when disconnecting.
• Always constantly monitor the temperature
of the battery pack while charging.
• Always end the charging process if the charger
or battery becomes hot to the touch or starts
to change form during the charge process.
Battery Charger
This light and compact charger (DYN4113) quickly and
easily charges 5–8 cell Ni-MH battery packs with an
installed EC3 ™ power connector.
Instructions
1. Connect the AC power cord to the power slot on
the charger, then connect the other end of the
power cord to an AC power source.
2. The Power LED and Charging LED will turn
GREEN when the charger is connected to
the AC power source.
3. Connect the battery pack connector to the
charge connector.
4. Press the On/Off button to charge the battery.
The Charging LED turns RED.
5. When the battery pack is fully charged, the Charging
LED will turn GREEN.
6. Press the On/Off button to stop charging. Disconnect
the battery pack connector from the charge connector.
CAuTION: If at any time during the charge
process the battery pack(s) becomes hot to
the touch, unplug the battery immediately
and discontinue the charge process.
4
EN