Shockwave 26
Testing your Boat in the Water
1. Carefully place the boat in the water.
2. Operate the boat at slow speeds near the shoreline.
Avoid objects in the water at all times.
3. Once you are comfortable operating the boat at
slow speeds, it is safe to operate the boat farther
from the shore.
Tip:
If you are using too much steering trim on your
transmitter to make the boat drive straight, return the
trim to neutral and mechanically center the rudder.
To do this, loosen the ball link from the rudder horn,
then turn the ball link on the linkage threads until the
rudder is properly centered.
4. Bring the boat back to shore when you notice
the boat starting to lose speed.
5. Power off the ESC and disconnect the battery packs.
6. Allow the motor, ESC and battery packs to cool before
charging the batteries or operating the boat again.
NOTICE:
Do not turn off the transmitter first
or the receiver may pick up stray signals and
run out of control.
When you are finished
1. Power off the ESC.
2. Disconnect the battery.
3. Power off the transmitter.
4. Remove the battery from
the boat.
Tip:
Always store the boat open
(without the hatch and inner
liner sealed) or moisture may
allow mold and mildew to
grow in the boat.
Motor Care
Seat the motor brushes by driving
smoothly on calm waters during use
of the first battery charge.
• Prolong motor life by preventing
overheating conditions. Undue
motor wear results from frequent
turns, stops and starts, pushing
objects, boating in rough water
or vegetation and boating
continuously at high speed.
• Over-temperature protection is
installed on the ESC to prevent
circuit damage, but cannot
protect the motor from pushing
against heavy resistance.
2
4
1
3
Boating Tips
Avoid boating near other watercraft, stationary objects,
waves, wakes and other rapidly moving water, wildlife,
floating debris or overhanging trees. You should also be
careful to avoid boating in areas where there are many
people, such as swimming areas, park waterways or
fishing areas. Consult local laws and ordinances before
choosing a location to pilot your boat.
Maximum speeds are only achieved when the water
conditions are smooth and there is little wind. A sharp
turn, wind or waves can turn over a boat when it is
moving quickly. Always pilot your boat for the wind and
water conditions so that the boat does not turn over.
When running your boat for the first time, we
recommend calm wind and water conditions so that
you can learn how the boat responds to your control.
When making turns, decrease the throttle position
in order to decrease speed and probability of flipping
the boat over.
NOTICE:
When running at full speed in choppy
waters, the prop may exit and re-enter the water
repeatedly and very quickly, subjecting the propeller
to some stress. Frequent stress may damage
the propeller.
CAuTION:
Never retrieve your boat from
the water in extreme temperatures, turbulence
or without supervision.
8
EN
Summary of Contents for Shockwave PRB0600
Page 54: ...Shockwave 26 54 ...
Page 55: ...Shockwave 26 55 ...
