Operating instructions NJ1 & FREAK Compact bike
30
immediately after such use and moving parts
need to be greased.
For all cleaning processes, only use
commercially available, household cleaning
agents. Do not use any abrasive cleaning
agents or aggressive, acidic cleaners, to
prevent scratching or fading of the coating or
the anodised parts.
In case the product becomes wet when using,
dry it after use.
The drive wheel should be regularly cleared of
contamination. It is recommended that you use
a soft sponge or a soft brush. The quick
release axles should be cleaned approx. every
8 weeks and lubricated with a little lubricating
oil with high corrosion protection properties (e-
g., Neoval MTO 300).
Use only water and soap to clean the seat and
back padding.
The product must not be cleaned using
steam or high pressure.
If you need care products for your product,
please contact PRO ACTIV.
27 Maintenance
27.1 General instructions
The product is not a maintenance-free device.
Therefore, please observe the following
instructions about maintenance.
For tyres with tread: As soon as there is
one or more points with less than 1 mm of
tread on the tyres of the product, the tyres
must be changed as otherwise there is an
increased risk of an accident.
For tyres without thread: As soon as there
is one or more points where the tyre carcass or
the puncture-proofing is visible on the product,
the tyres must be changed as otherwise there
is an increased risk of an accident.
When maintaining the brakes and the
gear components, it is imperative that the
operating instructions of the manufacturer
which were included in delivery are followed.
Only manufacturer's original parts may be
used when ordering spare parts.
Repairs and conversions to the product
may only be carried out by your dealer or PRO
ACTIV.
Tightening torques and securing details for
fastening elements as shown in the table in
chapter 33 must be observed.
27.2 Service schedules
There is some
maintenance work or checks
which should be carried out by the user
themselves
at regular intervals (approximately
every 4 weeks depending on the frequency of
use):
The chain should be cleaned and
lubricated with chain oil (observe the
manufacturer's instructions).
Check the tyres for damage, foreign bodies
and any cracks that form.
Check the function and ease of running of
the quick release axles on the running
wheels.
Check the cable housings are seated
correctly and tightly in the gear cable
holders.
Cables and lines should be checked for
kinks and crushing.
Check the brake pads.
Check the tyre pressure and correct if
needed (the tyre pressure should always
be as printed on the tyre covers).
If you should discover any problems
during these checks, please immediately
contact your dealer or PRO ACTIV. Service
and repair work on the product may only be
carried out by your dealer or PRO ACTIV.
