Operating instructions NJ1 & FREAK Compact bike
23
After every adjustment, check that the
neck rest is firmly attached in its position. If
necessary the tension can be adjusted by
turning the nut of the quick release lever
clockwise until it reaches the end stop.
Figure 41: Nut of the quick release lever
20 Collision guard
Figure 42: Collision guard
20.1 Collision guard mount
To remove the collision guard, both M6 fixing
screws (AF 4 mm) are undone on the right and
left inlet. Now the collision guard can be
removed from the inlet.
Figure 43: M6 fixing screws on the clamp on the
axle tube
20.2 Mounting the collision guard
Figure 44: Inlet of the collision guard with several
boreholes
For mounting the collision guard, the collision
guard is pushed onto both inlets. In doing so,
ensure for the correct position of the collision
guard on the inlet as there are several
boreholes on the inlet. Then both M6 fixing
screws (AF 4 mm) are tightened to 7 Nm and
secured with thread lock fluid.
Figure 45: Collision guard mounted
Nut of the quick release
lever
M6 fixing screw
Inlet
M6 fixing screw
