This is the printer interface port in the rear side of GP unit.
*1 When not using the INIT signal, the 10 pin connection becomes
unnecessary.
Recommended Connector:
FCN-787P014-G/R <manufactured by FUJITSU, Inc.>
Recommended Cover:
FCN-780C014-D/E <manufactured by FUJITSU, Inc.>
•
Do not connect to pin #12 and #13.
4
Printer Interface
7
14
1
8
Pin Connection
Pin #
Signal
Name
1
PSTB
2
PDB0
3
PDB1
4
PDB2
5
PDB3
6
PDB4
7
PDB5
8
PDB6
9
PDB7
10
*1
INIT
11
BUSY
12
NC
13
NC
14
GND
When making a cable, please be aware of the following:
<For RS-422 Connection>
•
The following pairs of pin #’s must be connected to each other
...#18 (CSB) <-> #19 (ERB)
...#21 (CSA) <-> #22 (ERA)
•
When connecting the RS-422 cable and the #9 (TRMX) and #10 (RDA)
points, a termination resistance of 100
Ω
is added between RDA and
RDB.
•
When the GP is set as a Memory Link type and the cable type is RS-422,
a 4-line system must be setup.
<For RS-232C connection>
•
Do not connect #9 (TRMX), #10 (RDA), #11 (SDA), #15 (SDB), #16
(RDB), #18 (CSB), #19 (ERB), #21 (CSA), and #22 (ERA).
