IMPORTANT! New carbon brushes tend to spark when first
used until they wear and conform to the motor's armature.
REPLACING THE TABLE INSERT
WARNING! Replace a damaged table insert immediately to
avoid a serious injury or damage to the tool. A damaged
insert may allow small components or debris to become
lodged. This debris can then block the saw blade during a
cut, causing the blade to shatter.
1.
Move the saw head aside to access the screws.
2. Remove the screws and the damaged table insert. Throw the
insert away or recycle it.
a. Some screws may be hidden behind the fence. Rotate the
table to expose these screws.
3. Install the table insert and secure with the removed screws.
4. Perform a mock-cut without power to check that the insert is
properly positioned. Adjust the insert if necessary.
CLEANING
1.
Brush sawdust and debris from the following components before
use:
a. tool vents
b. safety guard, guard spring and pivot points
c. the circular saw disc
d. the table insert
2. Only clean the tool with mild soap and a damp cloth.
3. Dry the steel components and lubricate to prevent corrosion.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
8987646
2-SPEED SLIDING MITER SAW
V1.0
Assistance available at www.princessauto.com or 1-800-665-8685
Page 20
