![background image](http://html.mh-extra.com/html/pro-point/8987646/8987646_manual_1607404017.webp)
iii. Place the stock on the mitre table and the blade along the
saw blade, between the teeth. Adjust the saw blade angle
until it is flush against the square's blade.
4. Tighten the bevel lock knob.
5. Loosen the adjustable fence knobs and slide the fences away from
the saw head.
6. Adjust the depth of the cut (Fig. 8).
a. Loosen the knurled knob on the
screw.
b. Turn the knob clockwise to decrease
the cut depth. Turn the knob
counterclockwise to increase the cut
depth.
c. Pull the saw head down, without
squeezing the trigger, to check the
depth. Adjust as necessary.
d. Tighten the knurled knob to lock the
depth screw in position.
e. Perform a test cut on a piece of wood to confirm the depth is
correct.
7.
Pull the mitre latch lever upwards to free the mitre table lock.
Rotate the table left or right until the mitre pointer aligns with the
desired angle on the mitre scale.
8. Release the mitre latch lever and push the table locking handle
down to secure the table in place.
9. Move each adjustable fence inward until they are no more than
5/16 in. (8 mm) away from the saw blade, then lock them into
position. Readjust the fence each time there is a change to the
mitre table or saw head angle.
PREPARING THE WORKPIECE
1.
Turn the blade by hand to ensure that it turns freely and smoothly,
before using the mitre saw.
Fig. 8
V1.0
2-SPEED SLIDING MITER SAW
8987646
Page 17
Assistance available at www.princessauto.com or 1-800-665-8685