a. If there is a gap one one side but not the other, first rotate the
saw blade and check on each side to see if it is warped.
b. The square may not be true. Test the square using the square
to draw a line on a piece of wood that has a flat edge. Flip the
square over so the stock is facing the other way. Align the
bade with the bottom of the previously drawn line and draw a
second line. You will only see one line if the square is true.
Any divergence shows the square is not true.
5. Tighten the lower locking nut while holding the screw in place with
the hex wrench.
6. Release the locking bolt to free the saw head.
ASSEMBLE MITRE SAW
COMPONENTS
1.
Raise and lower the saw head to make sure
the safety guard is functioning correctly.
2. Lower the saw head to ensure it does not
touch the table insert. Check the saw blade
alignment and table insert installation if it
does.
3. Attach the dust bag or a dust collection
system to the mitre saw's dust port (fig. 6).
WARNING! Only use the dust bag with wood or wood-
like materials. Metal chips may ignite the bag's fabric,
resulting in a fire. Plastic chips may adhere to the bag's
interior.
a. Pinch the dust bag's retainer clip to spread the bag's opening
and place it over the dust port so the ring will sit behind the lip
(Fig. 4) Release the clip and position the bag so the main
compartment is hanging down.
b. Make sure your dust collection system is designed to handle
the workpiece's material. Attach the intake hose to the dust
port and secure.
Fig. 6
8987646
2-SPEED SLIDING MITER SAW
V1.0
Assistance available at www.princessauto.com or 1-800-665-8685
Page 14
