POWER CORD SAFETY
1.
Insert the power cord plug directly to the power supply whenever
possible. Use extension cords or surge protectors only when the
tool's power cord cannot reach a power supply from the work area.
a. When operating a tool outside, use an outdoor extension cord
marked W-A or W. These cords are rated for outdoor use and
reduce the risk of electric shock.
2. Do not operate this tool if the power cord is frayed, damaged or
poorly spliced, as an electric shock may occur, resulting in
personal injury or property damage.
3. Discontinue use if a power cord feels more than comfortably warm
while operating the tool.
4. Keep all connections dry and off the ground to reduce the risk of
electric shock. Do not touch the plug or wiring with wet hands.
5. Prevent damage to the power cord by observing the following:
a. Place the power cord in a position that prevents it from coming
into contact with the tool or getting caught by the workpiece.
The cord should always stay behind the tool.
b. Do not pull on the cord to disconnect the plug from an outlet.
c. Keep the cord away from heat, oil, sharp edges or moving
parts.
d. Never carry the tool by the power cord
6. Position the cord so it is not be stepped on, tripped over or
otherwise subjected to damage or stress.
7.
Do not wrap the cord around the tool, as sharp edges may cut
insulation or cause cracks if wound too tight. Gently coil cord and
either hang on a hook or fasten with a device to keep cord together
during storage.
UNPACKING
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do so
could result in a malfunction and personal injury.
8987646
2-SPEED SLIDING MITER SAW
V1.0
Assistance available at www.princessauto.com or 1-800-665-8685
Page 10
