![background image](http://html.mh-extra.com/html/pro-point/8819864/8819864_user-manual_1607364008.webp)
8819864
Solar Auto-Darkening Welding Helmet
V1.0
With Blue Lens Technology
8
For technical questions call 1-800-665-8685
ASSEMBLY
The welding helmet is preassembled. Remove the protective film
from both lenses before use.
ADJUST THE WELDING HELMET FIT
The headband should be adjusted both in diameter and height.
The angle between face and helmet should also be adjusted
(recommended 10° to 12°).
1. Adjust the headband diameter with the adjusting knob (#14) on
the headband. Twist clockwise to tighten and counterclockwise
to loosen.
2. Adjust the headband height by releasing the segmental
positioning plate (#18) and changing the top strap hole.
3. Adjust the helmet position on the headband. There are three
slots on the headgear slider (#12). Once the slot is chosen,
tighten the angle adjustment knobs. Make sure the same slot
is chosen for both sides for proper vision.
4. Adjust the helmet to get the desired viewing angle. Once the
angle is correct, tighten the two angle adjustment knobs (#2)
connecting the headband to the helmet shell until snug. The
helmet should still swing up, but it should not drift downward
when in place for welding.
OPERATION
BEFORE WELDING
1. Ensure that the internal and external protective films are
removed from the lenses.
2. Check that the batteries have sufficient power to operate
the helmet.
3. Check that the arc sensors are clean and not blocked by dust
or debris.
4. Check for head band tightness before each use.