7
3. Loosen the Seat Knob (29) a few turns. Next,
pull the Seat Knob outward, insert the Seat Post
(6) into the Frame (1), and then release the Seat
Knob.
Move the Seat Post upward and down-
ward slightly to make sure that the pin on the
Seat Knob is engaged in one of the adjust-
ment holes in the Seat Post.
Next, push the Seat Post Guide (46) downward
into the top of the Frame (1). Attach the Seat
Post Guide with an M4 x 5mm Screw (70). Then,
retighten the Seat Knob (29).
3
6
1
46
70
29
4. Attach the Seat (20) to the Seat Post (6) with
four M8 Locknuts (66) and four M8 Split Washers
(72).
Note: The Locknuts and Split Washers
may be preattached to the underside of the
Seat.
4
20
72
66
6
5.
Tip: To avoid pinching the Reed Switch
Wire (31), position it as shown in the inset
drawing.
Apply a small amount of the included grease to
the Handlebar Axle (33). Insert the Handlebar
Axle into the Frame (1) and center it.
5
31
1
Grease
33
Avoid pinching the Reed
Switch Wire (31)
31
33
1
Summary of Contents for XP Whirlwind 320
Page 21: ...21 NOTES...
