Princeton Instruments PI-MAX4, Manual

Page: 291 / 326

291
Appendix D: Extender Bracket Kit
An Extender Bracket kit (part number
2530-0085) is shipped with each
PI-MAX4. After securing the bracket
at the rear of the PI-MAX4, you can
mount the PI-MAX4 to any
laboratory table with either 25 mm or
1 inch hole spacing.
Perform the following procedure to
secure the plate to the camera:
1.
Remove the extender bracket and
the three (3) 6-32x1/4” flathead
screws from the bag.
2.
Turn the camera upside down.
3.
With the rear of the camera
facing you, place the tongue of
the bracket into the cutout under
the now topmost edge. The text
on the bracket should be visible.
4.
Secure the plate with the three
screws.
5.
Turn the camera right side up and
secure it to the laboratory table. If
you will be using one or more
mounting holes at the bottom
front of the camera, tighten the
fastener(s) there before tightening
down the fastener(s) at the
extender bracket.
See Figure D-1 .
NOTE:
The table mounting holes in the plate are elongated to allow for
tolerance variations.
REMOVABLE EXTENDER BRACKET
1/4-20 THREAD
M6x1.0
THREAD
2.00
M6x1.0
1/4-20
M6x1.0
M6x1.0
1/4-20 1/4-20
225.0mm
9.00
0.20
5.1
1/4-20 THREAD
50.0mm
4411-0139_0171
Figure D-1: Extender Bracket Kit Mounted to a
PI-MAX4