Princeton Instruments NIRvana-LN, User Manual, Page: 53 / 122

Chapter 6 WinSpec/32 and WinView/32 First Light Procedure 53
3.
From the WinSpec/32 menu bar, select
Setup —> Detector Temperature
.
Configure the detector temperature parameters as indicated in Table 6-2 .
When the array temperature reaches the configured target temperature, the
Detector
Temperature
dialog will indicate that the temperature is
Locked
.
Once temperature lock has been established, the temperature will remain stable to
within ±0.05°C.
NOTES:
1. Some overshoot may occur which may cause temperature
lock to be lost briefly and then quickly re-established.
When reading the actual temperature reported by the
application software, there may be a small difference
between the configured and reported temperature when
lock is established. This is normal and does not indicate a
system malfunction.
2. The Detector Temperature dialog does not display
temperature information during data acquisition.
4.
From the WinSpec/32 menu bar, select
Acquisition —> Experiment Setup…
. Verify
and/or configure the parameters as indicated in Table 6-3 .
Table 6-2: WinSpec/32 Target Temperature Configuration
Parameter Value Notes
Target Temperature -190°C This information is read from the camera.
Table 6-3: WinSpec/32 Experiment Setup Configuration
Parameter Value Notes
Main Tab
Exposure Time 100 ms
Accumulations & Number of Images 1
ROI Tab
These parameters define the region of interest (ROI).
Spectroscopy Mode This option is selected
Full Loads the full size of the chip into the edit
boxes.
Store Stores the Pattern for future reuse.
Timing Tab
Timing Mode Free Run
Shutter Control Normal
Fast Mode/Safe Mode Safe Mode