Primus DAM 9, Service Manual

Page: 87 / 128

516514
85
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
Section 6
Adjustments
58. LEVELING LEGS
(Figure 64)
NOTE: Dryer should be installed on a solid and
level floor.
a. Place dryer in position, adjusting the legs until
dryer is level.
NOTE: Legs can be adjusted outside the dryer by
using a 1-1/4 inch size wrench, or from inside the
dryer (with lower front access panel removed) by
using a 1/4 inch drive ratchet with extension.
b. Keep dryer as close to the floor as possible. All
four legs must rest firmly on the floor so weight
of the dryer is evenly distributed. The dryer
MUST NOT rock.
IMPORTANT: DO NOT move the dryer at any time
unless the dryer is completely assembled. DO NOT
slide the dryer across the floor once the leveling legs
have been extended as the legs and base could
become damaged.
Figure 64
To reduce the risk of serious injury or death
by carbon monoxide and other gases in gas
dryers, carefully read and follow all
instructions given in this section.
W005
WARNING
D426SE3A
LEVELING
LEG
DRYER
BASE