516514
35
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
d. Dual Coin Drop Installation
(1) Gently work new coin drop into meter case
with the drop’s front face plate down. Refer
to Figure 20.
(2) Carefully pull front of coin drop up and
forward, so the drop’s front face plate
clears the meter case’s door switch bracket.
Refer to Figure 21.
(3) Rest the two coin-return stops on top of the
coin drawer housing, as shown in
Figure 22.
(4) Grasp top of coin drop front face plate
between the two drops, as shown in
Figure 21.
(5) Lift up front face plate of coin drop with
one hand, while gently pushing down rear
of drop with other hand, so the bottom of
the drop’s front face plate clears coin
drawer housing. Refer to Figure 23.
(6) Carefully slide coin drop forward into
position, as shown in Figure 24. (Front face
plate of coin drop should be secure against
front plate of meter case.
(7) Using a 7/16 inch socket with No. 310P4
1/4 inch Ratchet Extension Tool, reinstall
the 2 locknuts shown in Figure 16. Tighten
locknuts firmly.
(8) Reinstall coin drawer switch. Refer to
(9) Reconnect wires by referring to the wiring
diagram located inside the control hood.
(10) Reinstall service door switch and wire
harness into meter case bracket. Refer to
Figure 15.
Figure 20
Figure 21
W413SE1B
COIN DROP
FRONT
FACE PLATE
METER
CASE
COIN
DROP
W414SE1B
COIN DROP
FRONT
FACE PLATE
METER CASE
DOOR SWTICH
BRACKET
Figure 22
W415SE1B
COIN
DRAWER
HOUSING
COIN-RETURN
STOPS
Summary of Contents for DAM 9
Page 1: ...DAM 9 SERVICE MANUAL INDUSTRIAL DRYERS PUBLICATION DATE 02 01 516514 ...
Page 2: ......
Page 127: ......
Page 128: ......