Tilt-Bracket Installation
Complete the instructions illustrated below to mount a Digital Clock/Timer using the supplied tilt mount bracket.
Installation
l
You may mount the tilt bracket directly to the wall with the four #10 screws and anchors (supplied).
l
Hard-wired installation requires a 120V~ power line in a junction box installed by a licensed electrician. The tilt bracket has a
center pass-through hole for the 120V~ pigtail. If a junction box is present, the tilt bracket also has mounting holes spaced to
allow direct attachment of the tilt bracket to the cover plate screw holes on the junction box.
NOTE
The RJ45 jack for the network cable is on the bottom of the clock/timer. Most building codes prohibit running network
cables through the same junction box as line voltage.
Tilt Bracket mount illustration
21
