Configure Settings
Access setting panel
To change the factory default settings, remove the small rectangular access panel located in the upper center of the face of the
clock/timer. To aid in removal, there is a small recess in the top center of this panel. The panel can be removed with a small
screwdriver by gently prying the center top edge of the access panel forward. Setting changes can be made while the clock/timer
is ON and changes take effect within a few seconds.
NOTE
When power is first applied to the clock/timer or the reset button is pushed, a decimal point flashes for approximately
three minutes while the clock/timer receiver is turned on to search for a Transmitter signal. If the clock/timer does not
receive a valid signal from a Transmitter for three days its colons will flash.
Set LED Dimmer Display
The LED Display is set to 100% by factory default.
Set Dimmer to 25%
To dim the LEDs by 25% for a 2.5" display set Dimmer 2 in the UP position and for a 4" display set Dimmer 8 in the up position, as
illustrated below.
Set Dimmer to 50%
To dim the LEDs by 50% for a 2.5" display set Dimmer 1 in the up position and for a 4" display set Dimmer 7 in the up position, as
illustrated below.
Set Dimmer to 75%
To dim the LEDs by 75% for a 2.5" display set Dimmer 1 and 2 in the up position and for a 4" display set Dimmer 7 and 8 in the up
position, as illustrated below.
11
