FocusMonitor FM+
35,0(6
34
Revision 03/2019 EN
11.4.6
Rotated measuring tip (
Device control > Advanced > Measuring tip
)
When necessary, you can turn the measuring tip or the entire device by 180 degrees and measure in this
position. If you rotate the measurement tip of the FocusMonitor FM+, to carry out a measurement “upside
down” for example, you will have to configure and save this in
Device control > Advanced
.
1. Click on one of the
< >
buttons
next to the figure showing the
FocusMonitor FM+
The figure is rotated 180 degrees.
2. Click on
Save device parameters
.
The confirmation window will ap-
pear. You will receive notification that
the locked area, if defined, must be
adjusted.
3. Check the checkbox next to
Ac-
knowledge
and click on
OK
.
• The locked area is reset.
• The measuring tip is saved in the
device in its rotated state
• The rotated measuring tip is applied
to all measuring modes.
4. Adapt the locked area to the rotated
measuring tip as described in chapter
