14
Chapter 1 Component Names and Functions
18
LAN speed LED
It lights depending on the LAN data transfer speed of
the Switch Blade as follows.
19
LAN link/operation LED
It lights or blinks depending on the LAN connection
status of the Switch Blade as follows.
20
LAN active LED
It blinks depending on the LAN transfer status of the
advanced KVM module as follows.
21
LAN link LED
It lights depending on the LAN connection status of the
advanced KVM module as follows.
22
10BASE-T/100BASE-TX connector
This is an advanced KVM module (option) connector.
Used for remote console.
23
Inlet
An AC power cable is plugged in.
24
DC Power LED
It lights depending on the status of the DC power of the
PSU as follows.
There is no DC power LED in the dummy PSU.
LED status
Server Status
ON (Amber)
Operating at 1000Mbps
ON (Green)
Operating at 100Mbps
Off
Operating at 10Mbps
LED status
Server Status
ON (Green)
LAN link is being established
Blinking
(Green)
Data is being transferred
OFF
The link is not established or the
connector is disabled.
LED status
Server Status
Blinking (Green)
Data is being transferred
LED status
Server Status
ON (Amber)
Operating at 100Mbps
OFF
Link is not established or LAN link
is being established at 10Mbps
LED status
Server Status
ON (Green)
Operating normally.
OFF
DC power is not supplied to each
server blade. When this LED is OFF
while AC power is supplied and the
main power of the chassis is on, there
is an error in the PSU. Contact an
office listed in the "Contact
Information" of "Start Guide"or
device administrator.
25
Warning LED
It lights depending on the status of the PSU as follows.
26
AC Power LED
Lights or blinks depending on the status of the AC
power of the PSU as follows.
There is no AC power LED in the dummy PSU.
27
System fan module LED
The LED is lit in green when a fan module is installed in
the system fan unit. The upper LED is for fan module 1
and the lower LED is for fan module 2.
28
System fan module error LED
The LED is lit in amber when an error is detected in the
fan module installed in the system fan unit. The upper
LED is for fan module 1 and the lower LED is for fan
module 2.
29
Management Blade master LED
It lights depending on the Management Blade operation
status as follows.
30
Management Blade error LED
It lights or blinks when a Management Blade error
occurs as follows. If this LED lights or blinks, contact
an office listed in the "Contact Information" of "Start
Guide" or device administrator.
31
10BASE-T/100BASE-TX connector (
)
An Unshielded Twisted Pair (UTP) cable is plugged in.
32
Serial port connector (9- pin) (
)
Connect using an RS-232C cross cable.
LED status
Server Status
ON (Amber)
There is an error in the PSU. Contact
an office listed in the "Contact
Information" of "Start Guide" or
device administrator.
OFF
Operating normally.
LED status
Server Status
ON (Green)
AC power is supplied to the PSU.
OFF
AC power is not supplied.
LED status
Server Status
ON (Green)
Operating in master mode
OFF
Operating in slave mode
LED status
Server Status
ON (Amber)
A Management Blade error has
occurred (non redundant
Management Blade configuration)
Blinking
(Amber)
A Management Blade error has
occurred (redundant Management
Blade configuration)
OFF
Operating normally.
