Using RFID
17
Section 3: Using RFID
A: SETUP
RFID Label Stock should have an antenna imbedded between the
label adhesive layer and the liner. The antenna should be oriented
to the front of the label stock and centered within the label.
Follow these instructions each time you load a new roll of RFID
Label Stock.
1.
Load your RFID label stock according to the instructions print-
ed on the inside cover of your RX900e and found in Section 2B.
2.
Before you start printing, adjust the slide bar so the
Reader/Writer marker is approximately 1/8" (3mm) left or
right from center chip of the antenna. Open the cover of the
printer. You will find the slide bar and marker near the front of
the printer right behind the tear bar.
Note:
Write success is less likely as you move the marker away from the center of
the label.
Label
RFID Chip
Antenna
Set Marker approxi-
mately 1/8" (3mm) left
or right from center
chip of antenna.
RFID Read/Write Marker
Tear Bar
Slide Bar Handle
Antenna
