Label Stock
13
labels across make sure the sensor corresponds to a place on
the stock that has a label and not a vertical gap.
The sensor can only be moved a maximum of 2.3 inches
from the left side of the printable area. This means that the
maximum diameter circular label that can be printed is 4.6
inches. For circular labels larger than 4.6 inches in diameter,
you must have a black mark printed on the back of the label
stock. This means that you must change the Stock Sensor Mode
to Reflective. The printer will now look for the black mark
representing the beginning of the next label instead of the
diecut. For more information on changing the Stock Sensor
Mode see Section 2D.
Through-Hole Labels
If you are using card stock or label stock that has a hole punch
or a notch to identify a transition from backing to label, you
can adjust the Stock Sensor to position it over the identifying
mark.
Center
of Circle
1 1/8”
1/2”
Center
of Hole
Through-Hole Labels
Circular Labels
Set Sensor Bar to 1 1/8" for 2" circular label (1/8" liner edge gap).
