Primera LX500, User Manual

Page: 46 / 52

42
Label and Roll Specifications
Max Min
Label/Print width 4.25" (108mm) 0.75" (19mm)
Liner width 4.25" (108mm) 1" (25.4mm)
Label height/length 24" (609.6mm) 0.75" (19mm)
Gap between labels 0.75" (19mm) 0.10" (2.5mm)
Width of thru-hole opening 0.5" (12.7mm) 0.375" (9.5mm)
Distance from edge of media 1.90" (48.3mm) 0.20" (5.1mm)
to edge of thru-hole
Reflective/Black Mark Width*
Equal to distance 0.10" (2.5mm)
between labels
Max Outer Diameter (OD) 5.0"(127mm) N/A
Inner Core Diameter (ID)
see roll specifications below
Stock Thickness** .0010” (10 mil) N/A
Distance from edge of media to Printer driver assumes 2 mm gap.
edge of label However, this is adjustable via the
left margin offset.
* The Reflective/Black Mark should be opaque to infared light. The
mark should be between the labels. The end of the mark should
correspond with the beginning of the next label.
**This is the recommended maximum. There are two factors that
determine whether the printer will accept any particular stock thickness.
1. The ability for the printer to pull the paper through the print area.
2. The ability for the sensor to read through the backing if the sensor is
set to die-cut.
If you are printing in continuous or reflective label sensing mode
number 2 does not apply. The fact that the printer must read through
the backing in die-cut mode will limit the thickness much more than the
printer's ability to pull the paper through the print area. However, if
you adjust opacity level of the liner enough to allow the label to be seen
by the stock sensor, the thickness will only be limited by the printer's
ability to pull it through the printer area. For these reasons the weight
or thickness of the liner is a variable that can not easily be defined.
Primera recommends and uses 40# liner with all label stock.