Primera LX500, User Manual

Page: 14 / 52

10
Hardware and Software Setup
C. USING FAN-FOLD LABEL STOCK
It is possible to use fan-fold label stock by feeding it through
the fan-fold slot in the the back of the printer.
Before feeding the fan-fold stock through the back of the
printer, lock the stock guide in the out position so the stock
guide rollers will
not interfere with
the label stock.
The stock guide
is spring loaded
and under
normal
circumstances it
will pinch any
label stock roll
inserted into the
printer.
To lock the stock
guide push the
tab located on the
bottom of the
moveable stock
guide to the out/
locked position.
D. INSTALLING THE INK CARTRIDGE
When the cartridge reaches 10% remaining you will be
prompted via the Status Monitor to replace the cartridge. If
quality still looks acceptable you can choose to ignore this
warning. However, you may waste labels if the cartridge runs
out of ink before the next warning at 0%. If you choose to
replace the cartridges follow the procedure below.
After installing a new cartridge, you may choose to run an
alignment print to achieve maximum quality. However, this
will require cancelling the print job. If you would like to enable
smooth transitions between ink cartridge changes, you may
choose to disable alignment print warnings. (See the next
section).
Stock Guide
Locked Unlocked