8 Label Stock
4. Place your roll of label stock on the Roll Arm and push it inward until it touches the
Roll Stop.
5. Flip up the Roll Guide and slide it inward until it touches the label stock. The Roll
Guide will automatically pull back slightly to the correct position. There should be
approximately a .040" (1.0 mm) gap between the roll guide and the roll.
Important Note:
Be aware that some label stock may have a core that is slightly too large for the roll or
the labels may have wrapped unevenly causing some to stick out beyond the edge of the core.
Both of these issues can cause feeding problems.
6. Pull the Movable Throat Guide outward to make room for the label stock.
7. Place the leading edge of the label stock under the "label stock" symbols on
the Throat Guides. The label stock should be placed far enough into the
throat of the printer to correctly position the Movable Throat Guide but not yet into the
printer itself.
8. Slide the Movable Throat Guide inward until it almost touches the label stock.
Important Note:
The label stock should be close enough to the Fixed and Movable Thoat Guides to provide
proper guidance but not close enough to pinch the label stock. If the label stock is pinched by the
guides, poor print quality or feeding problems could result.
9. Feed the label stock further into the printer until it senses the label and automatically
feeds it through the printer. If the printer fails to feed the label stock, press the Load/
Feed button on the front panel while continuing to guide the label stock into the
printer. If the printer does not automatically grab and feed the stock or continues to
feed the stock without stopping check the Stock Sensor position or mode (Section 2C
or 2D).
Do Not Pinch!
Roll Arm
Roll Stop
Roll Guide
Label Stock
895936 - 030615
Do Not Pinch!
Movable Throat Guide
Fixed Throat Guide
Summary of Contents for LX1000e
Page 87: ...P N 511431 201019...
