PrimeArray 4xxx, User Manual

Page: 25 / 208

Installing the 1U rack-mount Model
4. Slide the hot swap hard disk tray slowly into the chassis,
push the outer rim of the tray as shown in Figure 3 until the
lever retract slowly toward the tray. Then, push the level
down as far as it can go to connect the hot swap hard
disk tray to the chassis.
Figure 3
1U rack-mount server installation
1. Pull out a HDD tray from the server.
2. Configuring the jumper on your hard disk using Cable
Select (CS) before installing to the hard disk tray. (Refer to
your hard disk’s user manual for the instruction)
3. Secure and mount a hard disk onto the HDD tray using
four screws under the tray.
4. Insert the HDD tray back in the server. Make sure the lever
of the HDD tray is properly in place.
5. Repeat Step 1 to Step 3 if necessary for the other HDD
tray.
6. Install the provide rack mounting handles at both side of
the NAS system.
7. Install the NAS system in the rack. (Refer to the paragraph
“Sliding Rails Installation” in Chapter 2 section 5)
Chapter 2
15