general installation instructions part 4 of 6
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wa
atest updates on
which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties
are void if Prima transformers are not used. Prima’s catalogs provide general information and suggestions for proper dimmer usage. Please consult
improper
s prior to installation.
Support points are required along the FIT System track run at 4ft maximum intervals. When using connectors, supports must be installed on the connector
or within 6” of the connector. Additional supports may be required when using certain glass pendants. It is strongly recommended that gloves are used when
handling the FIT II System track. Oils and dirt from fingers can sometimes permanently mark the finish. Track should be cleaned with a damp cloth and thoroughly
dried before fixture installation.
(22-65240 ~ 22-65248)
13615 Marquardt Ave. Santa Fe Springs, CA 90670
Ph. 562-407-3079 . Fx. 562-407-3069
www.primalighting.com
Rev. 021408
end power feed -
H
FIT II System end power feeds are available in one model which have powerfeed entry on the end (22-79121 shown in the example below)
the side (22-79122) or the top (22-79123). Insert the connector into open end of a FIT track length. Secure the powerfeed by tightening the
set screws with a flat head screwdriver at the top and bottom of the connector. Insert the transformer’s low voltage secondary leads into the power
entry holes on the connector. Using the supplied hex wrench, secure the transformer leads by tightening two set screws for each wire lead.
Transformer low voltage leads must be 10 AWG THHN stranded.
Tighten screws
on both sides
Tighten
screws
on both
sides
Low voltage leads from
transformer. 10AWG THHN
stranded
Follow all local and national electrical codes.
For assistance please call Prima Customer Ser
vice at 562-407-3079
for stem support
G1
G2
G3
G4
G5
G6
Mounting stem assembly
w/ mounting disk and
track bracket
Locking knob
Mounting
screws
Anchors
G
Be sure that the items indicated below are included in the package. Mount screw anchors in the mounting surface so that they align with
the holes in the mounting disk. Secure the mounting disk to the mounting surface with the included screws. Secure the track with the
locking knob. Insert the knob into the large hole on the side of the track bracket. Rotate the track locking knob 90º clockwise to lock the track.
Insert the track into the
track bracket
90º clockwise
Insert locking knob
Tighten inner knob
(22-65240 ~ 22-65248)
Follow all local and national electrical codes.
For assistance please call Prima Customer Ser
vice at 562-407-3079
(22-79121, 22-79122, 22-79123)
REV. 052416
