Z11
www.pridemobility.com
33
V I I I . C A R E A N D M A I N T E N A N C E
Storage
Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries
from the power chair. See VI. Batteries and Charging.
WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be
damaged.
Cleaning Instructions
WARNING! Never hose off your power chair or place it in direct contact with water. Your power chair
has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
Tire/Wheel Replacement
If you have pneumatic tires and you have a flat tire, you can replace the tube. If your chair is equipped with a solid tire
insert, then you must replace the whole wheel assembly. Replacement tires, tubes, and wheel assemblies are readily
available through your authorized Pride Provider.
WARNING! To avoid possible injury, be sure that the controllers power is turned off and the
power chair is not in freewheel mode before performing this procedure.
WARNING! Completely deflate the tire before attempting repair.
WHEEL HUB
TIRE
NUTS
FRONT RIM HALF
REAR RIM HALF
Figure 21. Jet Z11 Drive Wheel
Follow these easy steps for a quick and safe repair
for both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tire, completely deflate it
before removing the wheel.
4. Remove the drive wheel nut from the wheel hub. See figure
24.
5. Pull the wheel off the axle.
6. Remove the nuts that fasten the two rim halves together. See
figure 21.
7. Remove the old tube from the pneumatic tire and replace it
with a new tube or replace the entire assembly if it is a solid
tire.
8. Screw together the two rim halves.
9. Slide the wheel back onto the shaft. Make sure that the key is
in the axle slot. See figure 24.
10. Reinstall the drive wheel nut onto the wheel hub and tighten.
11. Inflate the pneumatic tire to
35 psi (2.4 bar)
.
12. Remove the power chair from the blocks.
