42
www.pridemobility.com Luna Victory Series
ABS PLASTIC SHROUDS
The front tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and are
coated with an advanced formula urethane paint.
A light application of car wax will help the shrouds retain their high gloss.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all prelubricated, sealed, and require no subsequent lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodi-
cally for wear by your authorized Pride Provider.
CONSOLE, CHARGER, AND REAR ELECTRONICS
Keep these areas free of moisture.
Allow these areas to dry thoroughly if they have been exposed to moisture before operating your
scooter again.
FUSE REPLACEMENT
In the event a fuse should cease to work:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown.
See figures 31 and 32
.
3. Insert a new fuse of the same rating.
WARNING! The replacement fuse must exactly match the rating of the fuse being
replaced. Failure to use properly rated fuses may cause damage to the electrical system.
BRAKE PADS
The brake pads on your scooter should be inspected periodicly for wear. Once the pads reach 2 mm or
1/8-th of an inch in thickness, they should be replaced. All brake pads should be replaced at the same
time. Contact your authorized Pride Provider for more information on replacing the brake pads.
NYLON LOCK NUT REPLACEMENT
Any nylon insert lock nut removed during the periodic maintenance, assembly, or disassembly of the
scooter must be replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause
damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available
at local hardware stores or through your authorized Pride Provider.
Figure 31. Working Fuse
Figure 32. Blown Fuse (Replace)
I X . C A R E A N D M A I N T E N A N C E