AdvAntAge - digitAl vAv diffusers
PRODUCT OVERVIEW & INSTALLATION INSTRUCTIONS
4
ACUTHERM ADVANTAGE - Manual
|
acutherm.com
Thermostat Options
The Advantage Master uses a wall
thermostat to accurately sense room
temperature in both cooling and heating
modes. Each thermostat comes
complete with a 35ft plenum rated cable
for connection to the Advantage Master.
The thermostat is available in six
options:
• Room Sensor (Blank Face).
• Dial Thermostat
• LCD Thermostat
• LCD Thermostat with motion sensor
for occupancy
• LCD Thermostat with CO2 and
humidity sensors
• Wireless Thermostat
The LCD thermostats are used to adjust
set points, display room temperature,
and configure the different parameters of
the diffuser.
nOte
When using the Room Sensor
or Dial Thermostat order a LCD-
SET (minimum of one per project) to
configure the diffuser.
Thermostat Adjustment
VAV Cooling, VAV Heating - Connecting
a wall mounted T’stat activates the
Advantage. Connect the T’stat to
Advantage using a supplied NETC35
(35’ plenum rated cable) by snapping
one side of the plug into jack inside of
thermostat, and the other side into the
T’Stat In jack. Setpoint is adjusted using
the wall mounted sensor.
See page 10 and 11 for more
thermostat details.
ROOM SENSOR
DIAL THERMOSTAT LCD THERMOSTAT
LCD THERMOSTAT WITH
CO2 AND HUMIDITY
LCD THERMOSTAT
WITH MOTION
SENSOR
WIRELESS
THERMOSTAT
figure 8 - drOne Wiring diAgrAM
RED LED
DC SIGNAL STATUS TO DRONE
GREEN LED
24 VAC SIGNAL STATUS
1 & 6 = 2 -10VDC
2 & 5 = COMMON
3 & 4 = 24VAC
FROM PREVIOUS
DIFFUSER
CABLE
CABLE
TO NEXT
DIFFUSER
INTERNAL WIRING
