PRG VARI LITE VL5, Service Manual

Page: 49 / 142

VL5 ™ WASH LUMINAIRE SERVICE MANUAL 39
Note: The pin will quickly become locked and very difficult to remove.
Step 14. Quickly check pin alignment. If pin is misaligned, use pliers to remove pin, discard pin, and repeat steps 11-
13 to install a new pin.
Important! Thoroughly remove all excess copper paste from pin, carrier holder and drive ring.
Step 15. Using clean, dry, lint-free cloth, remove all excess copper paste from pin, carrier holder and drive ring.
Step 16. Repeat Steps 9 through 13 for remaining guide ring pin locations, as necessary.
Step 17. At modified filter panel assembly, check drive ring movement. Drive ring should slide around unit from stop
to stop without binding. If binding occurs, pin may not be straight. Check all four pins for interference and,
if needed, replace pin.
Step 18. Re-install filters. Refer to "Color Filter and Diffuser/Douser Panel Replacement" on page 34 .
Step 19. Reassemble luminaire by doing Steps 3–7 in reverse order.