PRG VARI LITE VL5, Service Manual

Page: 48 / 142

38 VL5 ™ WASH LUMINAIRE SERVICE MANUAL
Step 10. Prepare copper powder paste.
a. Take room temperature water and mix in more salt than can be dissolved (i.e., there will be salt at
bottom of container).
b. Place some copper powder into another container and add enough salt water to form paste. If too
much salt water is added, pour or blot it off.
Note: Install each pin separately. If copper paste sets before pin is inserted, drive ring will have to be replaced.
Step 11. Work copper paste into three grooves and around base of new pin.
Step 12. At drive ring, using installation tool (10.9624.0109), carefully press prepared pin through drive ring groove
into carrier holder until tool is even with drive ring flange. Figure 2-22.
Figure 2-22: Drive Ring Pin Installation
Step 13. At newly installed pin location, using setting tool (10.9624.0110), press pin until it is flush with outer face of
drive ring. Approximately 3/16" of pin should protrude from carrier holder. Figure 2-23.
Figure 2-23: Drive Ring Pin Setting
PININS1
Installation Tool
(10.9624.0109)
Drive Ring Pin
Carrier Holder
Drive Ring
Bulkhead
PINSET1
Set Tool
(10.9624.0110)
Carrier Holder
Drive Ring Face
Bulkhead
Drive Ring Pin