PRG VARI LITE VL5, Service Manual

Page: 56 / 142

46 VL5 ™ WASH LUMINAIRE SERVICE MANUAL
VL5/VL5B:
a. At tilt-side yoke leg, at terminal strip, disconnect lamp power bundles (from input cable side). Slide
wires back through yoke leg.
b. At ground stud, using 5/16" nutdriver, remove three 6-32 Keps nuts securing ground cable ring
terminals and remove ring terminals.
c. Slide input cable ground wire back through yoke leg.
VL5Arc:
a. Using diagonal cutters, remove cable tie securing pan cable to pan mechanism.
b. Partially remove relay.
1) At relay, using #2 Phillips screwdriver, remove two 6-32 X 5/8" PPZ screws and two #6 lock
washers securing relay and top relay adapter plate to bottom relay adapter plate, and remove relay
and top plate.
Figure 2-28.
Figure 2-28: Removing Relay to Access Cables
Relay
6-32 X 5/8” PPZ
Screw (2)
#6 Internal Tooth
Lock Washer (2)
Top Adapter Plate
Disconnect Green Switch
Wire (Contact “B”)
Disconnect Diode
and Jumper Cables
Bottom Relay
Adapter Plate