PRG VARI LITE VL5, Service Manual

Page: 39 / 142

VL5 ™ WASH LUMINAIRE SERVICE MANUAL 29
b. At tilt-side yoke leg, using diagonal cutters, remove cable tie securing tilt cable to tilt mechanism.
Figure 2-12.
Figure 2-12: Disconnecting Wires at VL5Arc Tilt-Side Yoke Leg
c. Partially remove relay.
1) At relay, using #2 Phillips screwdriver, remove two 6-32 X 5/8" PPZ screws and two #6 lock
washers securing relay and top relay adapter plate to bottom relay adapter plate, and remove relay
and top plate.
Figure 2-13.
Figure 2-13: Removing Relay to Access Cables
2) At contact "B", disconnect green disconnect switch wire.
3) Disconnect diode and jumper cable assembly connectors.
4) Feed green disconnect switch wire back through yoke leg cutout and pull through to opposite yoke
leg.
Cable Tie
Tilt Mechanism
Relay
6-32 KEPS Nut (3)
Tilt Cable
Collet and Pulley
Cable Tie (2)
Ground Cables (2)
Acorn Nut
Tilt Tube
Adjustment Screw
6-32 X 5/16" PPZ Screw (3)
Flat Washer (3)
Relay
6-32 X 5/8” PPZ
Screw (2)
#6 Internal Tooth
Lock Washer (2)
Top Adapter Plate
Disconnect Green Switch
Wire (Contact “B”)
Disconnect Diode
and Jumper Cables
Bottom Relay
Adapter Plate