PREPLINE PSPS40, User'S & Technical Manual

Page: 17 / 24

PSPS40 / PSPT40 . 15 .
13. 13. 13. 13. OS OS OS OS----2130D Back Feed 2130D Back Feed 2130D Back Feed 2130D Back Feed setting setting setting setting
1. Under the normal working mode, press and hold 7 and ON/OFF key for more than 3s to enter this mode. In this
mode, you can set the back feed (OS-2130D).
2. The WEIGHT window disPSPT40ays “SETUP”, the UNIT PRICE window disPSPT40ays “BAK.FED”(Back Feed), and the
TOTAL
PRICE window disPSPT40ays “DISABL”(Disable).
3. Use 1 key to select "ENABLE" (OS-2130D will feed about one more inch so that the user can see the whole label.),
use 0 to select "DISABLE", use ENTER key to confirm and exit this mode.
14.
14. 14.
14. OS
OS OS
OS----203/213 Origin
203/213 Origin 203/213 Origin
203/213 Origin setting
setting setting
setting
1. Under the normal working mode, press and hold 8 and ON/OFF key for more than 3s to enter this mode. In this
mode, you can set the origin point (OS-2130D).
2. The WEIGHT window disPSPT40ays “SETUP”, the UNIT PRICE window disPSPT40ays “ORG.X”(Origin.X), and the
TOTAL PRICE
window disPSPT40ays the X direction offset number.
3. Use digit keys and Clear to input X offset (0-255), press Enter key to confirm the input and go to the next step.
4. The WEIGHT window disPSPT40ays “SETUP”, the UNIT PRICE window disPSPT40ays “ORG.Y”(Origin.Y), and the
TOTAL PRICE
window disPSPT40ays the Y direction offset number.
5. Use digit keys and Clear to input Y offset (0-255), press Enter key to confirm the input and the OS-2130D will print
out a new blank label samPSPT40e using new start position, and then exit this mode
15.
15. 15.
15. PSPT40
PSPT40 PSPT40
PSPT40U u
U u U u
U uPSPT40
PSPT40 PSPT40
PSPT40oad and download
oad and download oad and download
oad and download
1. Connect the scale to PC through RS232 interface, run PSPS40.exe, this software can only process *.xls files.
(The following is ExamPSPT40e for PSPS40-1530)
2. Software searches all serial ports on PC, and tries to connect with the scale. In the Status bar, it will separately
disPSPT40ay present serial port, baud rate, data format. Take the following figure for examPSPT40e,
“COM2,2400,8N1” refers to the present serial port COM2, baud rate 2400, data format 8N1. If the connection
status disPSPT40ays “Connecting the scale”, it means the Software is searching PSPS40 scale, if it disPSPT40ays
“The scale is connected”, it means the Host has been connected with the scale.